T O P I C R E V I E W
|
4.6Notchback
Member # 12644
|
posted
Wassup guys so im having an issue with my car.the theft light keeps blinking and it won't start.I did a 4.6 whole body swap into a foxbody but idk im thinking its the gauge cluster since its not it's original one for that computer and key any suggestions or solutions to fixing this thanks lmk
|
SLOW95GTS
Member # 10365
|
posted
I think you have to get the computer tuned to turn off the pats system.
|
4.6Notchback
Member # 12644
|
posted
Do you know were I would get that done?
|
SLOW95GTS
Member # 10365
|
posted
I think any online tune chip could do it, dirtydirtyracing.com is good place to start.
|
70stang351w
Member # 9948
|
posted
if your near sac contact sacstangdriver he had a contact up in sac area to do this or their was some members in the vendor section that have the tuning capabilities to turn it off/
|
Venomousnotch
Member # 8695
|
posted
**You must have two original keys to perform this procedure. If you only have one key, you WILL have to take it to the dealer to get it programmed**
1. Insert and existing (working) key into the ignition cylinder.
2. Turn the ignition cylinder ON (RUN) and back to OFF. Ignition should stay on for at least ONE SECOND.
3. Remove the existing key and, within TEN seconds, insert a second working key and turn it to ON (RUN) and the back OFF. Ignition must be in ON for at least ONE second, but no more than TEN seconds. Remove the key.
4. Insert the new key before TWENTY seconds have elapsed and turn it to ON (RUN). Leave it the ON position for at least ONE second and turn back to OFF.
5. The security light will light up for THREE seconds to indicate that the new key has been successfully programmed.
6. To program additional keys, repeat steps 1 through 5
This is how I did mine.... Good luck
|
HaulinAss Motorsports
Member # 541
|
posted
I believe you text me about this the other day.
The secuity key ,transponder (under dash) gauge cluster and computer/ecm is programmed to work together.
If the parts are mismatched the vats system needs to be reprogrammed. Any reputable auto lock smith has the programmer to do it. If you can't find someone I can get you in contact with one.
|
4.6Notchback
Member # 12644
|
posted
Everything is from the same car 2000 mustang gt steering column with 2 original keys, dash harness,engine harness,computer the only thing different is I put a cobra gauge cluster I didn't have the original one and the body harness is off a different car but I don't think that one matters
|
70stang351w
Member # 9948
|
posted
Wouldnt think that would matter i ran a cobra cluster in my gt without an issue...make sure harness are connected all the way? seen that happen once on this swap.
|
4.6Notchback
Member # 12644
|
posted
My brother in law put a 03 cobra cluster in his 2000gt and it wouldnt turn on either so he put his gt cluster back and it worked fine idk it's weird I'm thinking is just the cluster hopefully
|
4.6Notchback
Member # 12644
|
posted
Ima go thru all the wiring make sure everything is connected correctly tho
|