Author
|
Topic: Longblocks, get your longblocks!! 347 331 SMALL BLOCK WINDSORS
|
turbo50
¯
Member # 6700
|
posted
Brand new.
Built by me, according to your specs (want it low side clearance, gapped for boost/nitrous, boost or all motor etc).
ALL NEW PARTS.
ALL NEW PARTS (REPEAT)
NO CORE REQUIRED!!!
BLOCK:
.030 in. overbore, proper clearances for a 3.40 in. stroke crank and H-beam rods, decked, line honed mains, and line bored cam bearings. tapped for pipe plugs and brass freeze plugs, a 1-piece rear main seal, rust protection, and a protective coat of your choice color paint. Compatible with factory hydraulic roller or hydraulic flat cams, and accepts mechanical fuel pumps for old school.
Rotating assembly:
347 or 331 cubic inches, I dont care either way! FORGED LIGHTWEIGHT PISTONS DISH OR FLAT TOP Scat cast iron crank 4340 I beam scat rods with ARP 8740s (I beam stronger on compression, H beams stronger on stretch, either will OUTLIVE the block so....) MOLY RINGS HP CHAMFERED BEARINGS BALANCED 28oz HARMONIC BALANCER INCLUDED (will work on 4 or 3 bolt) Flexplate of your choice (flywheel additional cost if stick shift)
CYLINDER HEADS:
Edelbrock E 205 aluminum heads .650 springs Comp cams rocker arms aluminum full roller Hardened pushrods ARP head bolts Full gasket set FMS lifters ARP oil pump driveshaft Cloyes timing set Nodular melling oil pump
CAMSHAFT:
Hi Tech custom cam
$4599 NO TAX
HAND BUILT
Dan
925-348-1534
Dart block, forged 4340 crank and H beam rod options along with ARP200 option, priced accordingly. PM for that info.
-------------------- .........when was the last time YOU built something with YOUR own hands?
I offer quality sidework at reasonable prices. PM ME
Posts: 7606 | From: Discovery Bay, California | Registered: Apr 2006
| :
|
|
turbo50
¯
Member # 6700
|
posted
DART BLOCK UPGRADE If you want to upgrade to 4340 crank, h beam rods, internal balance, dart SHP block then the price is:
$6499 for the longblock above with the mentioned upgrades.
Ive shopped around before. This cannot be beat unless you assemble it yourself and find used parts.
There are NO used parts in the above motor.
Dan
925-348-1534 [ November 02, 2012, 10:02 PM: Message edited by: turbo50 ]
-------------------- .........when was the last time YOU built something with YOUR own hands?
I offer quality sidework at reasonable prices. PM ME
Posts: 7606 | From: Discovery Bay, California | Registered: Apr 2006
| :
|
|
turbo50
¯
Member # 6700
|
posted
I am now adding screw in freeze plugs for an additional fee on NON DART or BOSS based applications.
Dan [ November 02, 2012, 10:03 PM: Message edited by: turbo50 ]
-------------------- .........when was the last time YOU built something with YOUR own hands?
I offer quality sidework at reasonable prices. PM ME
Posts: 7606 | From: Discovery Bay, California | Registered: Apr 2006
| :
|
|
|