This is topic Longblocks, get your longblocks!! 347 331 SMALL BLOCK WINDSORS in forum Vendor's FOR SALE Section at Northern California Ford Owners .
To visit this topic, use this URL:
https://californiafords.com/cgi-bin/ultimatebb.cgi?ubb=get_topic;f=9;t=000341
Posted by turbo50 (Member # 6700) on
:
Brand new.
Built by me, according to your specs (want it low side clearance, gapped for boost/nitrous, boost or all motor etc).
ALL NEW PARTS.
ALL NEW PARTS (REPEAT)
NO CORE REQUIRED!!!
BLOCK:
.030 in. overbore, proper clearances for a 3.40 in. stroke crank and H-beam rods, decked, line honed mains, and line bored cam bearings. tapped for pipe plugs and brass freeze plugs, a 1-piece rear main seal, rust protection, and a protective coat of your choice color paint. Compatible with factory hydraulic roller or hydraulic flat cams, and accepts mechanical fuel pumps for old school.
Rotating assembly:
347 or 331 cubic inches, I dont care either way!
FORGED LIGHTWEIGHT PISTONS DISH OR FLAT TOP
Scat cast iron crank
4340 I beam scat rods with ARP 8740s (I beam stronger on compression, H beams stronger on stretch, either will OUTLIVE the block so....)
MOLY RINGS
HP CHAMFERED BEARINGS
BALANCED
28oz
HARMONIC BALANCER INCLUDED (will work on 4 or 3 bolt)
Flexplate of your choice (flywheel additional cost if stick shift)
CYLINDER HEADS:
Edelbrock E 205 aluminum heads .650 springs
Comp cams rocker arms aluminum full roller
Hardened pushrods
ARP head bolts
Full gasket set
FMS lifters
ARP oil pump driveshaft
Cloyes timing set
Nodular melling oil pump
CAMSHAFT:
Hi Tech custom cam
$4599 NO TAX
HAND BUILT
Dan
925-348-1534
Dart block, forged 4340 crank and H beam rod options along with ARP200 option, priced accordingly. PM for that info.
Posted by turbo50 (Member # 6700) on
:
DART BLOCK UPGRADE If you want to upgrade to 4340 crank, h beam rods, internal balance, dart SHP block then the price is:
$6499 for the longblock above with the mentioned upgrades.
Ive shopped around before. This cannot be beat unless you assemble it yourself and find used parts.
There are NO used parts in the above motor.
Dan
925-348-1534
[ November 02, 2012, 10:02 PM: Message edited by: turbo50 ]
Posted by turbo50 (Member # 6700) on
:
I am now adding screw in freeze plugs for an additional fee on NON DART or BOSS based applications.
Dan
[ November 02, 2012, 10:03 PM: Message edited by: turbo50 ]
Fueled by Ford Mustang Owners
on CaliforniaFords.com