|
Author
|
Topic: ford ranger hydraulic clutch wont disengage
|
ddarkslayer
¯
Member # 10688
|
posted
 
 
I have a 1994 ford ranger and when I slowly depress my clutch it does not disengage from the disk. When I snap the pedal to the ground it disengages. I can even hold the pedal down and it will stay disengaged. What could it be? Air in the line a bad slave cylinder? let me know.
Posts: 307 | From: Folsom | Registered: Feb 2011
| :
|
|
Venomousnotch
¯
Member # 8695
|
posted
Sounds like your slave cylinder is failing...Check and see if there's any moisture in the bell housing area.... ![[patriot]](graemlins/patriot.gif)
--------------------
🏁•2004 MUSTANG SVT COBRA•🏁
"WHEN THE WHINING STARTS,IT MEANS JUSTICE IS ABOUT TO BE SERVED"..
Posts: 7610 | From: *NORTHERN*KILLA4NIA* | Registered: Oct 2008
| :
|
|
redvenom
¯
Member # 12651
|
posted
Yea pretty puch.... try bleeding
--------------------
1990 Gt
Some what stock
1993 GT vert-(stolen)
Posts: 623 | From: cali | Registered: Dec 2012
| :
|
|
Tom Renzo
¯
Member # 13165
|
posted
Sounds like the cup in the slave master is shot.But if you see brake fluid in the bell housing you found the issue. But it sure sounds like a bypassing slave master. Normally when the release cylinder in the bell housing blows out it wont disengage at all. But if you have brake fluid in the bell that is a good giveaway it blew out.
[ 2014-07-06, 02:09 PM: Message edited by: Tom Renzo ]
--------------------
I spend money i don't have. Building cars i don't need. To impress people i don't know.
Posts: 557 | From: CT | Registered: Sep 2013
| :
|
|
ddarkslayer
¯
Member # 10688
|
posted
the TOB is chirping to
Posts: 307 | From: Folsom | Registered: Feb 2011
| :
|
|
Tom Renzo
¯
Member # 13165
|
posted
Well then you definitely have to pull the TRANNY. It is not very hard to do that clutch.
--------------------
I spend money i don't have. Building cars i don't need. To impress people i don't know.
Posts: 557 | From: CT | Registered: Sep 2013
| :
|
|
jose92vert
¯
Member # 8694
|
posted
Slave cylinder failing. Foot to replace the master cylinder with it also.
Posts: 14 | Registered: Oct 2008
| :
|
|
jose92vert
¯
Member # 8694
|
posted
Slave cylinder, I always do it pairs with master cylinder
Posts: 14 | Registered: Oct 2008
| :
|
|
Email this post to someone!
Printer friendly view of this Ford topic
