T O P I C R E V I E W
|
lfg91
Member # 12245
|
posted
So I had my coworker come help me and install a billetflow hub and pulley on my 03 cobra and he cranked it in a little passed the snout, we used the VMP puller/ installer tool and I know billetflow sells a hub removal plate to remove the hub. Is there another way I can go about removing the hub or atlest a way to back it out so it can be flush with the snout?
|
Greasy
Member # 5258
|
posted
I would be more worried about it being aligned with the other pullies rather than aligned with the snout.
|
lfg91
Member # 12245
|
posted
Yea it doesn't its too far in the belt won't wrap around the idler how it should, I was going by the write up on billetflows website and it says the hub has to be flush with the blower shaft
|
Greasy
Member # 5258
|
posted
The VMP tool won't remove it a little bit?
|
lfg91
Member # 12245
|
posted
The vmp tool will remove smaller pulleys that are pressed on I believe not ones that are on with a hub
|