|
Author
|
Topic: t-rex pump relay
|
maeco
¯
Member # 2578
|
posted
 
 
how do you find out if the relay is bad?
i hear the intank but not the t-rex.i bypass the relay and i hear the t-rex humming.
this must mean the relay is bad,right?
can i get this at kragen?
where?
--------------------
Looking for clean white mustang email me
Posts: 2409 | From: bay area | Registered: Mar 2003
| :
|
|
Stan G
¯
Member # 6226
|
posted
How are you powering the t-rex relay ?
Assuming you are activating 12v ( not ground)to turn the fp on,
check to make sure you have ~ 12v on the relay secondary , check to make sure you have continuity
or 12 v to the fp.
if no, trace your wiring back to the 12v source
if yes check for 12v on primary on 1 side and ground on the other to insure it is being powered to close
--------------------
1985 RX-7, 347/T-5 , T/F T/W heads, typhoon intake, Tfs2 cam, pulleys, 2500 lbs .
3.63 rear gears , Megasquirt
Posts: 105 | From: Sun Coast , Florida | Registered: Nov 2005
| :
|
|
|
|
88DroptopGT
¯
Member # 2535
|
posted
Did you check port 85 with a test light? As per the instructions it should light momentarily with the ignition switch. If not, you tapped the wrong wire in the fuel pump harness.
If your test light works, then your fuse is either hooked up sloppy, blown or your ground isn't good enough.
Posts: 3978 | From: 707 | Registered: Mar 2003
| :
|
|
maeco
¯
Member # 2578
|
posted
found out the problem.
where i crimped the wire one was barely
on there.so now its all good.
thanks guys.
--------------------
Looking for clean white mustang email me
Posts: 2409 | From: bay area | Registered: Mar 2003
| :
|
|
Glenn
¯
Member # 520
|
posted
Maeco what is your intank fuel pump? If it is a 255, just ditch the T-Rex.
--------------------
S-Trim,331,H/C/I
"JohnB groupie train"
My Car
DragGuam
Posts: 2009 | From: Stationed on a Pacific Island, Guam | Registered: Oct 2001
| :
|
|
|
Email this post to someone!
Printer friendly view of this Ford topic
