T O P I C R E V I E W
|
85CHP510
Member # 9690
|
posted
So im puttin my sn95 spindles and rear end tomorrow....for the front do i need to do any modifications or.can i.just go.ahead and bolt on the spindles.and calipers etc....also.when putting shocks do.i.get the shocks for my 89 or for the sn95??
|
gercolla1
Member # 3068
|
posted
all you need up front are some washers for the ball joints and some diff type of brake line fitting. im sure someone can be more specific [ December 28, 2011, 12:52 PM: Message edited by: gercolla1 ]
|
Jaejae5.0
Member # 7958
|
posted
all you need is some washers so you dont run out out thread..and i believe the brake line fitting is a (weatherhead 7828)and you only need it for the passenger side
|
sydewayzLX50
Member # 10217
|
posted
All i needed was the weatherhead 7828 fitting for the brake line, and 6 washers (3 per side) the washers i used are 5/8" i.d. and the smallest o.d. i could find. I think i bought them from fastenal.
|
MUSTTANGUY
Member # 2251
|
posted
The Weatherhead 7828 is the correct adapter fitting for the passenger caliper hose to body hard line. You can also use CarQuest but will have to have them cross reference the Weatherhead part # to their part #. You can also order stainless steel braided hoses with the correct fittings from Maximum Motorsports. Drivers side hose will bolt right up as is. While the washers "will" work, I am not a fan and supply machined stainless steel spacers (.330) with all my kits. Your existing fox struts will fit as there is no change in the lower strut mounting of the SN95 spindles to strut mount.
|
5.0 LsX
Member # 10017
|
posted
your struts will fit as long as its not a 4cyl..if you are going to replace them anyway, get the fox struts, only difference is they are shorter
|
SmallBlock Speeder
Member # 11220
|
posted
quote: Originally posted by MUSTTANGUY: The Weatherhead 7828 is the correct adapter fitting for the passenger caliper hose to body hard line. You can also use CarQuest but will have to have them cross reference the Weatherhead part # to their part #. You can also order stainless steel braided hoses with the correct fittings from Maximum Motorsports. Drivers side hose will bolt right up as is. While the washers "will" work, I am not a fan and supply machined stainless steel spacers (.330) with all my kits. Your existing fox struts will fit as there is no change in the lower strut mounting of the SN95 spindles to strut mount.
What this guy says I bought some spindles off him a while back knows his stuff very helpful too was more then willing to help.
|