T O P I C R E V I E W
|
04cobreezy
Member # 6416
|
posted
ok..so i love my cobra, but i can't say i know much about it. I'm looking to do some minor mods to it, but not go overboard with it. Can you guys give me some ideas of what i can do to pump it up a bit.. I already have a bassani exhaust, but i'm not sure what else i can do...thanks in advance for the help...
|
Joooestang66
Member # 2828
|
posted
Here's a good start.....
Kenne Bell Superchargers
|
93PONY
Member # 60
|
posted
One of the best bang-for-the-bucks modification would be a pulley swap.
I'd recomend a 4lb lower pulley & new gatorback belt, however a cheaper route is to go with an upper pulley & idler setup. The larger lower pulley will help stave off belt slip, while the upper pulley only setup may have some belt slip. Either route will give you a SIGNIFICANT increase in power across the RPM band.
You will need to retune the car after the swap.
|
asskickn88
Member # 4957
|
posted
quote: Originally posted by 93PONY: One of the best bang-for-the-bucks modification would be a pulley swap.
Or you could just trade it to me for my Fox. Its easy to work on and will cost you a lot less to mod too!
|
Throttle Stop
Member # 5515
|
posted
Depends on what you're looking for. If you want power, a pulley/ tune would be the way to go. Combine that with a good Mid-pipe and you'll get a little more. And, don't forget the intake side. A good CAI will help the power output.
If you're looking for suspension, than lowering springs with some good caster/ camber plates are a good start. It all depends on what you want. Give us a call at (916) 780-4646 or stop by and we can help you with whatever you decide.
Tim The Throttle Stop 1200 Plumber Way Ste 120 Roseville, Ca. 95678 (916) 780-4646
|
03SHKER
Member # 1397
|
posted
Yeah, pretty much what everyone has said. 2.81 upper pulley & tensioner, catted X pipe, CAI and a tune are all good starts, and won't break the bank.
|
04cobreezy
Member # 6416
|
posted
good deal..will definately do the pulley, get a cold air system and lowering springs with caster camber plates... as to the fox trade...hahahha..good one! i already have a 89 notch that i'm working on also..
|