T O P I C R E V I E W
|
stanger00
Member # 13818
|
posted
I have a water heater and a gas furnace installed in my garage. It has framing built around both units but the sheetrock that was there has been ripped out. I'd assume this was done to meet code before we bought the house.
This is what I want to hide using the existing frame to hang removable panels:
1. I will hang a removable panel in front of the water heater with a vent at the bottom for combustion.
2. A permanent panel on the non combustion side of the gas furnace.
3. A removable panel with vent on the combustion side of the gas furnace.
Are 1,2,and 3 legal and meet code? Or will I have to fashion panels out of gypsum?
|
NorCalRydaz
Member # 3233
|
posted
Are you going to wrap your water heater?
|
stanger00
Member # 13818
|
posted
No, was just going to leave it as is.
Also, I want this to be safe too not just to be compliant. Don't want to start a accidental fire.
|
FSTRDNU
Member # 12
|
posted
quote: Originally posted by NorCalRydaz: Are you going to wrap your water heater?
Go put your hand on your water heater and then come back and read your post.
|
SL0BRA650
Member # 10274
|
posted
You should call your local Fire Protection Bureau in regarding this matter, and possibly if necessary, schedule an appointment for an fire safety inspector to check it out.
|
stanger00
Member # 13818
|
posted
quote: Originally posted by FSTRDNU: quote: Originally posted by NorCalRydaz: Are you going to wrap your water heater?
Go put your hand on your water heater and then come back and read your post.
They have a point. The wraps aren't terribly expensive.
quote: Originally posted by SL0BRA650: You should call your local Fire Protection Bureau in regarding this matter, and possibly if necessary, schedule an appointment for an fire safety inspector to check it out.
I will do this but I figured there would be a bunch of contractors on here with some familiarity about codes like this.
|