T O P I C R E V I E W
|
fast305s
Member # 11897
|
posted
A friend of mine put in some longtubes in his 93 notch, while doing so he managed to smash the portion of the wiring harness riding on top of the tranny when he lifted the motor. Long story short the wires didn't like it much an lit up for a second. Nothin serious but it did damage the harness a bit. My question is what harness would he need to get to replace it( I'm pretty sure its the portion of the harness holding the clutch position sensor an what not) an what would be the easiest way to get the old one out an the new one in? Any help would be much appreciated [ November 25, 2012, 07:28 PM: Message edited by: fast305s ]
|
REDLIGHTING
Member # 11296
|
posted
I think It's the reverse lights and clutch switch
|
fast305s
Member # 11897
|
posted
I'm assuming its a bitch to get all that out?9
|
REDLIGHTING
Member # 11296
|
posted
I think it comes in under the driver seat and then to clutch pedal, the reverse wiring not sure just follow it. You can always replace the damage section.
|
89Rodknocker
Member # 2951
|
posted
If it is the nuetral safety switch that goes to the trans i have a harness id sell yall. pm if intrested.
|
Nifty50
Member # 9987
|
posted
check the muffler bolts
|