This is topic 347 Stroker motors BRAND NEW in forum Vendor's FOR SALE Section at Northern California Ford Owners .
To visit this topic, use this URL:
https://californiafords.com/cgi-bin/ultimatebb.cgi?ubb=get_topic;f=9;t=000342
Posted by turbo50 (Member # 6700) on
:
Brand new.
Built by me, according to your specs (want it low side clearance, gapped for boost/nitrous, boost or all motor etc).
ALL NEW PARTS.
STANDARD FORD CRATE MOTOR BLOCK
NO CORE REQUIRED!!!
.030 in. overbore, proper clearances for a 3.40 in. stroke crank and H-beam rods, decked, line honed mains, and line bored cam bearings. tapped for pipe plugs and brass freeze plugs, a 1-piece rear main seal, rust protection, and a protective coat of your choice color paint. Compatible with factory hydraulic roller or hydraulic flat cams, and accepts mechanical fuel pumps for old school.
Rotating assembly:
347 or 331 cubic inches, I dont care either way!
FORGED LIGHTWEIGHT PISTONS DISH OR FLAT TOP
Scat cast iron crank
4340 I beam scat rods with ARP 8740s (I beam stronger on compression, H beams stronger on stretch, either will OUTLIVE the block so....)
MOLY RINGS
HP CHAMFERED BEARINGS
BALANCED
28oz
HARMONIC BALANCER INCLUDED (will work on 4 or 3 bolt)
Flexplate of your choice (flywheel additional cost if stick shift)
$2490 NO TAX
Pan, timing cover available at additional cost!
As an example, CHP shortblocks are 2600 by the time you pay shipping and taxes and there is a 4 week wait RIGHT now, unless you are a dealer....
These are HAND built for your application.
Dan
925-348-1534
[ October 29, 2012, 05:37 PM: Message edited by: turbo50 ]
Posted by CornOil_&_Boost (Member # 5888) on
:
*wonders when idiots will ask if these are 2 or 4 bolt block*
for $2500...it's a pretty sick deal though...
[ October 29, 2012, 06:05 PM: Message edited by: CornOil_&_Boost ]
Posted by turbo50 (Member # 6700) on
:
2 bolt and SHORTBLOCK only
Posted by NEIGHT (Member # 8741) on
:
How much would this run but DART based so it can hold some good power?
Posted by turbo50 (Member # 6700) on
:
quote:
Originally posted by NEIGHT:
How much would this run but DART based so it can hold some good power?
You'd want better internals to take advantage of such a nice block but pm me for real world dart block 347 pricing
Posted by turbo50 (Member # 6700) on
:
If you supply your own core motor then subtract $150 from the above price.
Fueled by Ford Mustang Owners
on CaliforniaFords.com