This is topic brake problem. 91 gt in forum Tech Talk at Northern California Ford Owners  .


To visit this topic, use this URL:
https://californiafords.com/cgi-bin/ultimatebb.cgi?ubb=get_topic;f=6;t=025330

---

Posted by OneFastNotch. (Member # 9537) on :
 
sn95 set up front /back i went to bleed my brakes and nothing comes out of the back brakes. only fronts. what could this be? i was thinking master?
 

---

Posted by 93 twintrbo (Member # 10475) on :
 
Remove the bleeder screws completely. Make sure the master cyl is full at all times and let it gravity bleed untill fluid starts to drip. Install the bleeders and start bleeding.

Sometimes if the bleeders dont have caps installed to keep the dirt and dust out, it will clog and not allow them to bleed properly. I usually remove the bleeder screws and clean the orfice out with a pick. Re-install them and start bleeding.
 

---

Posted by dvuspny (Member # 10949) on :
 
Did you install the adjustable proportion valve? You won't have sufficient pressure to the rears. Also the car must be level or close to. Best on all four jack-stands. Make sure they are stable.....

[ September 25, 2011, 01:29 PM: Message edited by: dvuspny ]
 

---

Posted by OneFastNotch. (Member # 9537) on :
 
proportion valve is inside the car.
 

---

Posted by 93sspCOUPE (Member # 8418) on :
 
did you start with bleeding the rears first? second dont pump the brakes that just airrates the fluid its one pump and hold then open the blled then tighten then allover again. my car was really dry from sitting and it took a good half hour. my suggestion get a vaccuum bleeder
 

---

Fueled by Ford Mustang Owners
on CaliforniaFords.com