|
Author
|
Topic: anyone know how to depin this harness connector?
|
BigBen
¯
Member # 10594
|
posted
 
 
I am trying to pull out the engine harness and I am having a hard time pulling the pins out of this connection, anyone know how to do it? It is for the 02 sensors connection and it is routed through the shocktower and I dont want to cut up this harness when pulling it out.
[ 2013-04-01, 02:04 PM: Message edited by: BigBen ]
Posts: 445 | Registered: Jan 2011
| :
|
|
Stang66
¯
Member # 10504
|
posted
You need a paper clip or pick to push up on the little hooks you see in the center of the connection
--------------------
1966 Ford Mustang
1990 Notchback
1975 Pontiac Trans Am 400ci
Posts: 754 | From: Stockton | Registered: Dec 2010
| :
|
|
turbo50
¯
Member # 6700
|
posted
You need a pin removal tool. Go to radio shack.
--------------------
.........when was the last time YOU built something with YOUR own hands?
I offer quality sidework at reasonable prices. PM ME
Posts: 7606 | From: Discovery Bay, California | Registered: Apr 2006
| :
|
|
BigBen
¯
Member # 10594
|
posted
thanks for the help fellas, Dan I went to my local radio shack and they had no clue what I was talking about lol, but I browsed around and they didnt have the tool instock.
Posts: 445 | Registered: Jan 2011
| :
|
|
|
|
Duncan Motors
¯
Member # 7045
|
posted
needle nose pliers pulls out that lil orange strait bar in the middle out. that is the holding clip that locks it all in place. once u get that out u will notice one lil tooth plastic tip that the strait bar was holding against your precise pin lol. a lil flat head screw driver will pull back that tooth and then u can easiely pull out the pin connector. a small needle nose and a small flaT HEAD SCREW DRIVER IS ALL U NEED. the tool dan mentioned is close for another style connector but not the one shown above.
Posts: 6310 | From: Vallejo | Registered: Sep 2006
| :
|
|
Email this post to someone!
Printer friendly view of this Ford topic
