|
Author
|
Topic: MM torque arm and BBK O/R x-pipe
|
The Nick
¯
Member # 2244
|
posted
 
 
In the install instructions, it says that some modifications to the crossover pipe might be needed. Does anyone have any experience with the combination of these two products so that I know what needs to be done before I get the car on the rack?
--------------------
Fast, Cheap or Reliable. Pick two and live with it.
Posts: 1215 | From: The Delta | Registered: Dec 2002
| :
|
|
BlackNGold
CaliforniaFords.com
Moderator
Member # 655
|
posted
"Some aftermarket H-pipes position the crossover tube closer to the rear of the car than the stock H-pipe...If you are unfortunate enough to have one of these H-pipes, the crossover tube will have to be cut out and moved forward to provide clearence for the Torque-arm crossmember..."~MM
Basically, unless you can weld you need to take it to a muffler shop and move the center section/crossover so that the cross member can fit....
You only need to do that if your H-pipes crossover tube is too far back and doesn't fit..... ![[patriot]](graemlins/patriot.gif)
--------------------
-SLOWER TRAFFIC KEEP RIGHT-
Posts: 5132 | From: Bay Area, CA | Registered: Dec 2001
| :
|
|
The Nick
¯
Member # 2244
|
posted
Yeah, I got that part of it. I was just curious to see if anyone has had any experience with these two parts and whether or not they did have to move the crossover section. Thanks for the help though.
--------------------
Fast, Cheap or Reliable. Pick two and live with it.
Posts: 1215 | From: The Delta | Registered: Dec 2002
| :
|
|
Email this post to someone!
Printer friendly view of this Ford topic
