|
Author
|
Topic: lowering springs install
|
maeco
¯
Member # 2578
|
posted
 
how do you put back the stock springs on a fox?
i normally pop out the stock springs by lowering the a arms and throw the lowering springs with no problem cus the after market spring is shorter.
but how do i put back a stock ones on there which spring compressor do i need?
--------------------
Looking for clean white mustang email me
Posts: 2408 | From: bay area | Registered: Mar 2003
| :
|
|
Stangs R Us
¯
Member # 4495
|
posted
gooooooooooood luck , i usually just cut a coil off the stock spring and work it in
Posts: 3100 | From: sacramento | Registered: Aug 2005
| :
|
|
maeco
¯
Member # 2578
|
posted
probably what iam going to do.sorry for the post on the wrong section can mods move it to tech section?
--------------------
Looking for clean white mustang email me
Posts: 2408 | From: bay area | Registered: Mar 2003
| :
|
|
BIGBALLFACTOR
¯
Member # 7277
|
posted
you need the spring compser that goes inside the spring
Posts: 6908 | From: okc | Registered: Dec 2006
| :
|
|
Pai
¯
Member # 8901
|
posted
Isnt this for sale section =]
SPRING COMPRESSOR FTW!
Or have a friend compress them by hand and simply just place them inside. Duhh
--------------------
'94 5.0 Trick flow heads,Trick flow cam,Shorties,Cold air, UnderdirvePulleys and 355 gears Formerly known as Projectfox87,
Posts: 218 | From: Sacramento | Registered: Jan 2009
| :
|
|
maeco
¯
Member # 2578
|
posted
quote:
Originally posted by Pai:
Isnt this for sale section =]
SPRING COMPRESSOR FTW!
Or have a friend compress them by hand and simply just place them inside. Duhh
quote:
Originally posted by maeco:
probably what iam going to do.sorry for the post on the wrong section can mods move it to tech section?
"have a friend compress them by hand and simply just place them inside. Duhh"
unless you have super man as a friend this is not possible. ![[Roll Eyes]](rolleyes.gif)
--------------------
Looking for clean white mustang email me
Posts: 2408 | From: bay area | Registered: Mar 2003
| :
|
|
Luke87GT
Lay'n more stripes
than Caltrans
Member # 21
|
posted
Maeco, with tall springs you leave the strut attached and pull out the two inner control arm bolts, and drop the control arm from the inside.
It helps to have 2 jacks to get the holes aligned again after the spring is in.
I've done it like this at least a dozen times.
Definitely takes a little coordination to get the holes aligned, so be prepared.
Posts: 7802 | From: San Mateo | Registered: Jul 2000
| :
|
|
SLPR93
¯
Member # 8769
|
posted
use a spring comperssor get it down as much as u could tie it up with a good rope put it in then cut the rope its geto but works for me ![[Wink]](wink.gif)
Posts: 1269 | From: modesto | Registered: Nov 2008
| :
|
|
Topic Closed
Printer friendly view of this Ford topic
