T O P I C R E V I E W
|
naked5.0notch
Member # 14058
|
posted
Hearing a knocking noise around the strut top area on the driver side hitting bumps. This is after the initial alignment
Set up is eibach sportline springs, kyb agx shocks/struts and upr caster camber plates along with upr upper and lower rear control arms
|
510.86.notch
Member # 9892
|
posted
Check your front sway bar mount.the spot welds on my wife's car started separated and making a clicking noise.just a thought.
|
naked5.0notch
Member # 14058
|
posted
Will check that out. Just looks like the top mount knocks and moves around with all the bolts tight
|
NEIGHT
Member # 8741
|
posted
quote: Originally posted by naked5.0notch: Will check that out. Just looks like the top mount knocks and moves around with all the bolts tight
The strut moves up and down with the bolts tight? Add a strut spacer
|
naked5.0notch
Member # 14058
|
posted
The center rod with it tight moves up and down a little so the ball bearing is moving up/down on the driver side. Pass side is tight
|
naked5.0notch
Member # 14058
|
posted
Can the caster/camber plates be rebuilt ?
|
*Als50*
Member # 6003
|
posted
Send them back to UPR for replacements.
|
naked5.0notch
Member # 14058
|
posted
Called upr they had some suggestions but I don't think they will take them back. They are roughly ten years old
|
*Als50*
Member # 6003
|
posted
Mine are a little older than yours and i told them either repair or replace them since it was not problem that they were failing. Sent them back. Got new ones. Don't take NO for an answer.
|
naked5.0notch
Member # 14058
|
posted
I will give that a try
|