T O P I C R E V I E W
|
macthizzle
Member # 3492
|
posted
Bank 1 and bank 2 running to lean and are about 25 percent.
|
jo_arce02
Member # 11777
|
posted
unmetered air getting in there and the computer is trying to make up for it. try spraying brake cleaner around the intake manifold and or vacuum hoses. also check the intake boot after the MAF or any hoses coming off that boot to the valve cover.
|
macthizzle
Member # 3492
|
posted
DTC for which Freeze Frame was Stored P0171,P0174 Fuel System 1 Status Closed Loop Fuel System 2 Status Not Supported Calculated LOAD Value 24.3 % Engine Coolant Temp 207.00 °F Short Term Fuel Trim - Bank 1 11.7 % Long Term Fuel Trim - Bank 1 25.0 % Short Term Fuel Trim - Bank 2 10.9 % Long Term Fuel Trim - Bank 2 25.0 % Intake Manifold Absolute Pressure 8.6 inHg Engine RPM 763 rpm
|
hurting your feelings
Member # 13641
|
posted
Pcv and the house for like to leak.
|
SacStangDriver
Member # 8304
|
posted
smoke test it before you do anything else. check for vacuum leak.
|
macthizzle
Member # 3492
|
posted
It has been smoke tested. Test showed no leaks, Can a dirty fuel filter cause this?
The truck runs fine I just need to pass smog. Rpms stay around 700 at idle. I don't know what else to check. [ 2016-04-06, 08:32 PM: Message edited by: macthizzle ]
|
ford521
Member # 14321
|
posted
Assuming its a V6 , very common for lower intake gasket/orings to shrink up ...may not see it in a smoke test. Also check for dirty Maf sensor will cause same thing
|