Author
|
Topic: 351w gap between intake & block
|
Blow_U_In_Reverse
¯
Member # 12298
|
posted
So i just tried to install a 351w trick flow lower intake manifold on to my 351w to do the efi conversion.. but there is a gap between the intake manifold & where it sits on the block.. all the bolts line up perfectly except for ONE bolt on the front driver side.. all the ports seem to line up too..
Any ideas why i could be having the issues?
Or will it be ok if i just lay down a thick layer of RTV on that part?
Dont want to mill down the intake because once i finish the efi swap, i will be swapping motor and using this same intake manifold withthe other motor.. i decided to use the existing motor for now since its a good running motor and will reduce the guess-work incase i have to troubleshoot..
-------------------- "Real Men Get BLOWN" -1993 Cobra "COBRUUH" -1984 T-Top Notchback #KurganTuned
Posts: 2688 | From: FiJi-925-650 | Registered: Aug 2012
| :
|
|
70stang351w
¯
Member # 9948
|
posted
check to see if there is a pin in block was reading my instruction for install and said early blocks may have several pins to help locate the stock intake.
Same 351w with the airgap?
-------------------- 1996 GT VERT /32v MOD - SOLD 1970 Mustang Coupe M-Code 351w
Posts: 1419 | From: 925 | Registered: Apr 2010
| :
|
|
Blow_U_In_Reverse
¯
Member # 12298
|
posted
quote: Originally posted by 70stang351w: check to see if there is a pin in block was reading my instruction for install and said early blocks may have several pins to help locate the stock intake.
Same 351w with the airgap?
Pin in the block? Where would the pin be?
And yeah same one.. i think the last owner might have had the same problem and forcefully tighten it, which is why it probably cracked..
-------------------- "Real Men Get BLOWN" -1993 Cobra "COBRUUH" -1984 T-Top Notchback #KurganTuned
Posts: 2688 | From: FiJi-925-650 | Registered: Aug 2012
| :
|
|
|