T O P I C R E V I E W
|
91LxMustang
Member # 11808
|
posted
I got a 1997 drop top cobra and my driveshaft is scraping its berly clearing were it connects to the transmission it hits the tunnel were the tranny is everytime i punch it it scrapes or with two people in the car i dont no if my driveshaft may be after market or how can i fix it???
|
87droptop50
Member # 7185
|
posted
Are you sure your tranny mount isn't worn or messed up ?
|
91LxMustang
Member # 11808
|
posted
Im going to check that out tomrorow?
|
Blind
Member # 3052
|
posted
Either engine/tranny mounts are bad or the rear end is lowered too much.
the most common aftermarket driveshaft is the ford racing aluminum one, it will look bright silver vs a stock iron one which will look like old rusty metal.
how low is the car?
|
91LxMustang
Member # 11808
|
posted
Yea the drive shaft is silver dont look rusted i have no idea on how mutch i the drop but its on eibacs
|
Blind
Member # 3052
|
posted
the ford racing aluminum one is a bit larger diameter than a stock driveshaft.
How much gap do you have in the fender to the rear tire?
My stock driveshaft would rub the parking brake bracket on my `97 fobra with my old solid axle setup that had about a 2" drop and about 1-2 fingers gap on the rear tires.
I would suggest installing a set of maxmimum motorsport poly spring isolators on the springs, it will raise it up just a tad and might be enough to stop the rubbing.
But also check the condition of the engine and transmission mounts.
|
91LxMustang
Member # 11808
|
posted
Im not sure on the drop in the back if i put on a stock driveshaft will it help the rear its not that low was actually thinkn of droping it lil more from the rear will adjustable control arms help?
|
Venom
Member # 9201
|
posted
Check the e brake bracket, my 94 had the same issue. On my car the bracket torn a bit And everybtime I launch hard it would scrape.
|