T O P I C R E V I E W
|
Mysnakebites
Member # 7950
|
posted
I want to convert my 96 cobra to e85 any shops doing this?
|
SLOWSN95
Member # 8269
|
posted
PM Sent
|
samsbolt390
Member # 11645
|
posted
N/m [ June 22, 2012, 11:06 AM: Message edited by: samsbolt390 ]
|
Greasy
Member # 5258
|
posted
quote: Originally posted by samsbolt390: Fill it and go. Your mileage will fall off though. When I switched my 95 I didn't do anything to it ran fine. I don't see any benefit with "stock" compression, 10:1 and up will make a difference. Lots of good info on the net and don't believe the E85 "Conversion kit BS"
He may need some fuel system components like a FPR, bigger injectors, and a fuel pump. If he is doing it to a newer car it will most likely need a tune.
|
CornOil_&_Boost
Member # 5888
|
posted
quote: Originally posted by samsbolt390: Fill it and go. Your mileage will fall off though. When I switched my 95 I didn't do anything to it ran fine. I don't see any benefit with "stock" compression, 10:1 and up will make a difference. Lots of good info on the net and don't believe the E85 "Conversion kit BS"
Yeah, I agree with this guy it's not like you need a silly thing like a tune or other fuel system components to get a HP benefit out of it...
yeah, just dump it in and go
in fact, even better...you'll be paying less for gas per gallon but your fuel mileage drops as well...win win?
|
samsbolt390
Member # 11645
|
posted
N/m [ June 22, 2012, 11:05 AM: Message edited by: samsbolt390 ]
|
Greasy
Member # 5258
|
posted
quote: Originally posted by samsbolt390: He didn't give any spec to his "build" if you just wanna run E85 "dump it in and go" any engine can benefit from a "tune". Alcohol requires additional FLOW (30% more is the usual base line. in the case of my 68' bigger carb, jets, fuel lines fuel pump in your case injectors MAF etc.) in order to achieve what stock engines are built to run on and with using normal pump gas swill.Alcohol has a lower specific gravity and combustion index contributing to its higher octane rating. Again there's lots of good info on the net. Sorry for the original lack of explanation. At least I tried instead of just "quoting" and wasting space with the "what this guy said" I feel dumberer already.
lol so you're assuming since you did it to a carburated '68 that all you need to do is put it in and go? I think a OBDII vehicle has a few more sensors and a more complex ECU then a carburated '68. Especially if you're running boost I wouldn't just "dump it in and go" that's when shit goes wrong and you're looking for a new engine.
|
samsbolt390
Member # 11645
|
posted
You read and answered my first post about my 95. Here I'll fix it.
|