T O P I C R E V I E W
|
dunrite
Member # 9861
|
posted
My 5.0 is bored .040 over and running a crane roller cam ( has .544 lift ) using stock type pistons and gasket matched 5.0 intake. Im running afr 165 heads with jba shorty headers. Drive train is stock t-5 with 3;73 in the rear. I have to go to the smog refferee cause I install this stuff in my jeep. My question is would the stock throttle body and maf with the stock air box hurt me much? Right now Im running bbk 70mm throttle body and maf with cai with 24lb injectors. When I floor it now sometimes you can feel the power fall off and come back as it climbs in rpms. Do you think thats caused by the pro-m maf isnt working right. Also the throttle body sticks coming off idle causing jerky take offs. So Ive read that the stock maf will handle an engine like my and would match the fuel mapping with 19lb injectors.
|
LXjames
Member # 10791
|
posted
the maf needs to be correctly calibrated for the injectors you are using. now for your sticky bbk. ive held one in my hands and seen this stick you speak of. when i went to turn the trhrottle it actually clicked and started moving. i dint like bbk just for that now. get you a holley or something
|
moeofit32
Member # 10393
|
posted
+1 bbk tb's suck mines stick all the time randomly hella annoying
|
Built88LX
Member # 10758
|
posted
quote: Originally posted by moeofit32: +1 bbk tb's suck mines stick all the time randomly hella annoying
+2 I always had the same problem with my bbk throttle body so im going to try the trick flow brand this time around hopefully that helps
|
79 cobra
Member # 10137
|
posted
snapped my holley bought it brand new only lasted 4-6 months and snapped and stayed WOT i got the trick flow 75mm tb to replace and no problems
|
FivePTSlow
Member # 7682
|
posted
All I've ever used were BBK Throttle Bodys I've had several with zero problems
|
92stangLX
Member # 3252
|
posted
The stick intake is hurting your power quite a bit. I would change it. Make sure the sticking is not caused by a linkage problem. You can check it by disconnecting the linkage and snapping the throttle body and seeing if it is sticking. If it is sticking throw it out and get a ford 65mm or accufab
|