T O P I C R E V I E W
|
clone nprogrss
Member # 10342
|
posted
im in the middle of takin this thing apart for my hci swap an dont hav a socket big enuff for the main pulley bolt!!
|
ddarkslayer
Member # 10688
|
posted
there is three bolts holding the pulley to the harmonic balancer and there is the one that is in the middle
|
Blind
Member # 3052
|
posted
I might be wrong, but last I remember it was somewhere around 24mm, if you get a large impact deep socket set you should have the correct size.
|
clone nprogrss
Member # 10342
|
posted
quote: Originally posted by Blind: I might be wrong, but last I remember it was somewhere around 24mm, if you get a large impact deep socket set you should have the correct size.
before i take this off do i even hav to take that off doin a hci swap??
|
Blind
Member # 3052
|
posted
probably be pretty hard to get the timing cover off if you don't.
and you'll need a socket and breaker bar to help set your timing and check piston to valve clearance and setup the rockers...
|
clone nprogrss
Member # 10342
|
posted
quote: Originally posted by Blind: probably be pretty hard to get the timing cover off if you don't.
and you'll need a socket and breaker bar to help set your timing and check piston to valve clearance and setup the rockers...
good lookin blind!!
|