T O P I C R E V I E W
|
CHP2981
Member # 9240
|
posted
I went to a test only station and the hydrocarbons were too high. My mods are stock block and heads gt40 tubular bbk throttle body and spacer 24lb injectors aeromotive fpr bbk equals and h pipe with 2 cats msd 6al and msd dist with coil and last is a Paxton 1220sl with a 255 walbro fuel pump. Any ideas would be appreciated on how to bring them down. Most of the parts have OE carb # and I have 2 cats. Trying to do it legit. [ August 15, 2010, 03:44 AM: Message edited by: CHP2981 ]
|
alexdel209
Member # 9239
|
posted
hydrocarbon is hac which is raw unburned fuel. adjust your fuel pressure reg if you can to get a lil less gass u should pass if still not then you need better cats and you will pas
|
ajs91CHPcoupe
Member # 10217
|
posted
+1 on the fuel pressure. disconnect the vacuum line to the fpr and adjust to 38-39 psi at idle then reconnect vacuum line. also make sure ignition system is good may not be complete combustion. [ August 15, 2010, 04:33 AM: Message edited by: ajs91CHPcoupe ]
|