|
Author
|
Topic: UCA install in a 87 Fox
|
PWR HNGRY 302
¯
Member # 6000
|
posted
 
 
Hey all,
I recently installed new bushings for the uca's on the diff and iam trying to install the uca's but I am having trouble with the alignment. Either the diff mount is on and the other point won't line up or the upper is on and the diff won't line up. Is there I trick to lining these up? Stock arms. Bushing is exposed is equal amount on either side of the diff.
--------------------
87 Fox- Restoration in progress
2014 Tacoma DCLB MGM
2017 Prius Prime (The Daily)
Posts: 2655 | From: SF Bay Area | Registered: Sep 2005
| :
|
|
92stangLX
¯
Member # 3252
|
posted
should line up. I think the UCAs are a PITA to get in though. You may have to have the bolts loose and wiggle the thing around 'til it lines up.
Posts: 5302 | From: San Francisco | Registered: Sep 2003
| :
|
|
Jdub
¯
Member # 2098
|
posted
It's a bit of a juggling act. Try raising or lowering the rearend, as well as placing your jack at the front or rear of the pumpkin (with the car on jackstands of course) in order adjust the bolt hole alignment. If you have a long 1/4" socket extension, you can stick that in one end to adjust the alignment so you can get a bolt started on the opposite side that you stuck the extension in. Just takes some patience....
[ March 03, 2009, 04:47 AM: Message edited by: Jdub ]
Posts: 54 | From: East Bay | Registered: Nov 2002
| :
|
|
HaulinAss Motorsports
Its a STREETRaceCar!
Member # 541
|
posted
Remove the lower part of the shockx which will allow it to move around more to get the uppers lined up easier.
[ March 04, 2009, 06:54 PM: Message edited by: HaulinAss Motorsports ]
Posts: 22509 | From: Sacramento | Registered: Nov 2001
| :
|
|
Email this post to someone!
Printer friendly view of this Ford topic
