This is topic 95 t-5 onto 90 block in forum Tech Talk at Northern California Ford Owners  .


To visit this topic, use this URL:
https://californiafords.com/cgi-bin/ultimatebb.cgi?ubb=get_topic;f=6;t=017827
Posted by 5.0MAV (Member # 7831) on :
 
Fellow Ford lovers,
workin on a 95 GT,didnt have an engine in it, ive got a 90 5.0 engine but still using the 95 t-5. Had a problem a while ago with a similar setup with the input shaft sleeve on the tranny rubbing on the crank causing the motor to seize once the bellhousing bolts were tightened,ended up trading that tranny for the right one never actually figured out the problem.Ive heard that the 95 tranny has a different shaft and sleeve? Is it possible to just swap the sleeve and shaft to the earlier t-5?If I could would the clutch and fork be the same as the earlier t-5 also? Your input is greatly appreciated. Take it easy fellas and Happy Friday. [patriot]
 
Posted by 2fstfru (Member # 453) on :
 
If you want to use a 94-95 t-5 onto a foxbody you would have to use the 94-95 bell housing.
 
Posted by jph331 (Member # 665) on :
 
The input shaft is longer on the 94-95 t5. Not sure about the bearing retainer(sleeve). You can buy a new input shaft or use the correct bellhousing. D&D performance has the parts you need and can answer any transmission related questions.
 
Posted by F.or O.nly R.eal D.rivers (Member # 7831) on :
 
Thanx for the info,I might be fine because on the last one I had a problem with i was trying to use an 89 bellhousing with a 94 tranny,i have the 95 bellhousing this time so it might work. Ill try it out and see how it works. [patriot]
 




Fueled by Ford Mustang Owners
on CaliforniaFords.com