T O P I C R E V I E W
|
BlowN67
Member # 4229
|
posted
well its time to start on the 351w. i pulled it out an notice very little if any surface rust on head surface an also notice some but not much in the water jackets an passages. will this be all ok for a rebuild or do i need to do something to it. was just going to crosshatch the cyl an put it together so any advice please
|
ProjectFox87
Member # 7048
|
posted
From what I've seen, You should be fine man. Just clean it off. I wirewheeled a little rust off one of my miata motors, it did leave some small scratches, so i dont recommend it, but it worked. Im sure there are other ways, like steel wool. Goodluck.
|
JohnB
Member # 969
|
posted
You'll be fine. Spray everything down with WD40 and wipe off with a coarse rag (shop rag). If it won't come off, use 800 grit wetsand paper WITH a light mineral oil; clean everything up with brake parts cleaner.
|
BlowN67
Member # 4229
|
posted
i shouldnt be worried about the little rust in the jackets an passages right. seemsabout normal i would think, an thanx again for everything.
|
JohnB
Member # 969
|
posted
Nope, don't sweat it. DO make sure all your freeze plugs are good while it's out...you don't wanna find out the hard way.
|
BlowN67
Member # 4229
|
posted
i got a new set of brass ones
|
Notch1320
Member # 2647
|
posted
John,
Finishing one of those projects would minimize the rust that forms on everythng from sitting...
J/K man... what are you building the 351 to put in?
|
BlowN67
Member # 4229
|
posted
just gathering parts any trying to get things together instead of all around the place
|
Fostang
Member # 3752
|
posted
just buy my 385 and be done with it. No need to go out and find parts.
|