289fia_cobra
Member # 3813
|
posted
I have a unique situation. I have a Cobra with headers that go straight down towards the side and ends with a flange where all 4 pipes are tightly welded together.
Hooker made these but they're off by about that 1/8-1/4" too far "up" from horizontal. Here's a pic of how it sits currently:
As you can see, its too close in the vertical orientation. Ideally, I need a full 1/4" gap up top.
So I need a shop that can make a slight bend downwards about 4" from the flange.
Any recommendation? ( Santa Clara area ideally.) [ September 27, 2007, 12:19 AM: Message edited by: 289fia_cobra ]
|