This is topic flat-spot when accelerating?? in forum Tech Talk at Northern California Ford Owners  .


To visit this topic, use this URL:
https://californiafords.com/cgi-bin/ultimatebb.cgi?ubb=get_topic;f=6;t=014425

Posted by SydeWayzSix (Member # 2222) on :
 
My car has been experienceing this problem on and off. Basically, when I am in 1st or 2nd gear and I floor the gas pedal, it sometimes feels like its falls on its face...but then begins to pull hard right after. It only occurs when the RPM's are below 3K. If I am above 3K RPM and then floor the pedal, it seems fine and pulls hard. Someone told me that it could be due to a faulty MAF sensor, but I'm not sure. Any ideas??
 
Posted by blind (Member # 3052) on :
 
with the key on and engine off, tap into the TPS sensor wires so you can read the voltage on a volt meter and check that the voltage goes from under 1 volt at idle (throttle closed) smoothly up to ~5volts at wide open throttle.

I would clean the MAF sensor also.
 
Posted by SydeWayzSix (Member # 2222) on :
 
I'll try that. Also, how do I clean the MAF? Do i clean the wires/connector, or the inside of the MAF??
 
Posted by kingmoochr (Member # 5834) on :
 
inside, very carefully, w/ maf cleaner, NOTHING ELSE
 
Posted by 93Cobra50 (Member # 4602) on :
 
I believe a light spray of brake cleaner on the element should clean it. I had the same problem, but I changed the whole unit
 




Fueled by Ford Mustang Owners
on CaliforniaFords.com