BlackNGold
CaliforniaFords.com Moderator
Member # 655
|
posted
Remove the distributor, making sure you mark where the rotor is pointing and where the base of the dist is on the block....
Once removed you have to get a punch to hammer out the ring pin on the dist gear, then get a puller and pull off the dist gear...I just used a 2 jaw puller...NOTE~Make sure you pay attention to how the gear came off, you don't want to try and install the gear upside down when you reinstall it...
Once you do that the shaft slides out and you can simply unbolt the PIP and bolt the new one in...Then you're gonna have to press the dist gear back on, making sure you line up the ring pin hole...Then carefully tap the ring pin back in the gear, but make sure you line up the hole or else you'll fuck the ring pin up...
Good luck
-------------------- -SLOWER TRAFFIC KEEP RIGHT-
Posts: 5132 | From: Bay Area, CA | Registered: Dec 2001
| :
|