This is topic 94 GT LONG TUBES ? in forum Tech Talk at Northern California Ford Owners  .


To visit this topic, use this URL:
https://californiafords.com/cgi-bin/ultimatebb.cgi?ubb=get_topic;f=6;t=012224
Posted by 94DropTop (Member # 5072) on :
 
Has anyone put long tubes on a 94 gt i tried one from the bottom no luck i pulled the headers off a 94 so i know they fit just cant seem to make them go in on my car

[ October 24, 2005, 08:04 PM: Message edited by: 94DropTop ]
 
Posted by rickm237 (Member # 5323) on :
 
i know that the steering shaft gets in the way. I would almost say that you have to lift the engine out to get those properly aligned --rick
 
Posted by 94gt (Member # 3060) on :
 
if they are like the equal lengths that i had on my old 94, I had to unbolt the motor mount and jack up the motor slightly to get them in... that may help
 
Posted by 94DropTop (Member # 5072) on :
 
thanks
 
Posted by Hungry Hippo (Member # 537) on :
 
you have to undo the mounts and tilt the engine. driver side, ondo the steering shaft. the pass side is a little harder. makes it a little easier to take the starter out
 
Posted by phil a (Member # 3596) on :
 
like the last two boneheads [Razz] said, take off the starter/steering shaft, loosen up the motor mounts and lift the motor a few inches, saves a lot of stress/hassles, plus it'll get your headers in w/o scratching the finish.

phil
 




Fueled by Ford Mustang Owners
on CaliforniaFords.com