T O P I C R E V I E W
|
94gt
Member # 3060
|
posted
I just finished installing a s-trim on my 94gt... it had the HO version, and I installed everything per the instructions. there were only a few things that I had to "redneck" like the thermostat housing didnt allow the bracket to line up correctly. I massaged the housing and beyond that, it was really trouble free.
but when I test drove it home just now, it seemed..... sluiggish, like the gas pedal was sticking. I did try and rotate the boost retard controller from 0-3 with the same results.
Would me already having a 255lph in my tank (in addition to the one that came with the kit) cause this?
I also got a CE light on the way home, Ill pull the codes tomorrow. [ February 07, 2005, 12:31 PM: Message edited by: 94gt ]
|
SydeWayzSix
Member # 2222
|
posted
sounds like a possible misfire..sluggish with a CE light...but i'm not sure Did you change your injectors and MAF at the same time?
|
94gt
Member # 3060
|
posted
no, since the system is designed to run on a stock set up i didnt. I'm ordering a fuel pressure guage and prolly some injectors.. any reccomendations on what size? I have another MAF thats calibrated for the 24'ers
|
Mr JoCo
Member # 1549
|
posted
How old are your spark plugs? what kind, did you regap them after the install? no huh?
|
SlowStockFox
Member # 1081
|
posted
good luck with that. i wish i could give u some info
|
92stangLX
Member # 3252
|
posted
Do you have an adjustable fuel pressure regulator? If so, what is your fuel pressure set at? How about the timing?
You may also want to check and make sure that all of the hose clamps for the blower inlet and outlet are tight. Also double check all the vaccum lines.
If you didn't do a tune up (plugs, wires, dist cap/rotor, and fuel filter) you may want to do one.
|
94gt
Member # 3060
|
posted
actually, I did buy new plugs, but the install kit said that I only needed to install them if the car had less than 10k on the current ones. The ones that I bought were 1 heat range colder, autozone didnt have any that were 2 ranges colder at the moment.
I have a low mile replacement dist, 5 month old wires, dist cap, rotor, ICM, and fresh oil change and filter.
also, the manual didnt say anything about the gap on the plugs? what should I set them at?
|
CDT
Member # 5004
|
posted
it could be related to your fuel pump and the FMU, I would suggest buying big injectors and dumping the FMU.
|
92stangLX
Member # 3252
|
posted
Is the car "sluggish" only when it is under boost or all the time? How does it idle?
|
94gt
Member # 3060
|
posted
quote: Originally posted by 92stangLX: Is the car "sluggish" only when it is under boost or all the time? How does it idle?
it seemed to idle lower, but I kinda expected it to drag a little more with the s/c on it. and its constantly sluggish when I gas it. Why would i need to get bigger injectors and ditch the FMU? and what size? thanks!
|
Fostang
Member # 3752
|
posted
Did you close the spark gap?
|
94gt
Member # 3060
|
posted
quote: Originally posted by Fostang: Did you close the spark gap?
to what? It didnt say how much to close it!
|
Fostang
Member # 3752
|
posted
.035
|
91 5.0
Member # 1527
|
posted
You shouldnt ditch the FMU unless you get the car tuned. The FMU is designed to raise fuel pressure and deliever more fuel under boost. Bigger injectors and no FMU without a tune may not be a good idea. As far as the plugs, i'd go about 34 thousandths.
|
94gt
Member # 3060
|
posted
ok, i just found a loose page that said .032-.040 ill do that and report back in a few hours!
|
94gt
Member # 3060
|
posted
ok, i regapped the plugs at .035 and it seemed to idle a lot better.
I kept getting a lean CE light, and found that my 2nd fuel pump wasnt switching on.
Fixed that, and now it feels like the gas pedal isnt wanting to go down easy. It also sounds like its mis-firing too. I made sure that when I reconnected the plug wires that I did them the same way they came out.
any suggestions? Please!!!
|
white1990stang
Member # 2307
|
posted
i know you just mentioned the fuel pump but what one wasnt turning on. my t-rex inline blew the fuse a few times. i didnt use the fmu or the boost retard when i installed mine. im running 42's and i got a tune and it runs awesome.
|
94gt
Member # 3060
|
posted
It turned out to be that I had #2 and #3 plug wires oops thanks guys!~
|
03SVTPower
Member # 518
|
posted
When are you gonna swing by the apartments again?
|
94gt
Member # 3060
|
posted
quote: Originally posted by 03SVTPower: When are you gonna swing by the apartments again?
when are you free? I work graves 0001-0800 so name a time or somethin!
|
03SVTPower
Member # 518
|
posted
quote: Originally posted by 94gt: quote: Originally posted by 03SVTPower: When are you gonna swing by the apartments again?
when are you free? I work graves 0001-0800 so name a time or somethin!
I should be back on mids myself next week or so, im on days right now training, ill wait til im on the same shift so we can work something out, like to check it out!
|