|
Author
|
Topic: Check this out
|
cheap
¯
Member # 858
|
posted
 
 
The pivot part of the rocker arm just kinda fell out. It's kinda lucky I even found it... I pulled the valve cover to check torque since i've been having a tick on the driver's side and it wasn't an exhaust leak, and on a whim I checked the pushrods to make sure they were secure and one wasn't. Is there anything special I need to do when I put the small piece back in? RTV or anything? Also the pushrod scuffed up the rocker a little bit, maybe a little chipping... you can kinda see it in the second pic, on the bottom of the hole. Thoughts?
Dave
--------------------
1965 Spyder GT
Posts: 1358 | From: Maine | Registered: Feb 2002
| :
|
|
cheap
¯
Member # 858
|
posted
Here's some collateral damage:
[ October 29, 2004, 06:30 PM: Message edited by: cheap ]
--------------------
1965 Spyder GT
Posts: 1358 | From: Maine | Registered: Feb 2002
| :
|
|
Quick 88LX
¯
Member # 1950
|
posted
I could be wrong but I am not sure those are fixable. I would think you need a whole new set. I am probably wrong but either way I wouldn't want to use something "fixed" in my valvetrain. That is just me though.
--------------------
"Men are Made, Not Born"
Car Picture : http://www.angelfire.com/theforce/quick88lx/
Original Member #495. Can I get my number back?
Posts: 1785 | From: Fairfield, CA/Okinawa, Japan | Registered: Oct 2002
| :
|
|
FasterDamnit
Bad Attitude
Member # 442
|
posted
You can buy one rocker and one pushrod. Do not attempt to repair. The manufacturer MIGHT replace it under warranty.
--------------------
'92 LX T5
Looked stock, went 11's 11.90 at 115mph.
'65 Mustang 347
www.fordmuscle.com
Livin' in the Carolina Pines
Posts: 2971 | From: NorCal | Registered: Sep 2001
| :
|
|
cheap
¯
Member # 858
|
posted
Really? The rocker wasn't really damaged much, just a little 'denting' at the end of the rocker... I JB Welded the small piece, which was undamaged, back into the rocker arm and haven't had any trouble with it so far.
How much does one rocker cost? I already bought a new pushrod ($2.99 @ napa)...
--------------------
1965 Spyder GT
Posts: 1358 | From: Maine | Registered: Feb 2002
| :
|
|
HaulinAss Motorsports
Its a STREETRaceCar!
Member # 541
|
posted
quote:
Originally posted by cheap:
I JB Welded the small piece, which was undamaged, back into the rocker arm and haven't had any trouble with it so far.
How much does one rocker cost? I already bought a new pushrod ($2.99 @ napa)...
okay you need to stop what your doing and go buy a new rocker arm.cmon man jb weld? you know whats gonna happen if that piece breaks off and goes thru your motor.you wont be worrying about spending $2.99 for a pushrod you will be looking for a whole new shortblock....I see your screename but this isnt the time to be ![[Big Grin]](biggrin.gif)
GO BUY A DAMN ROCKER!
Posts: 22509 | From: Sacramento | Registered: Nov 2001
| :
|
|
Email this post to someone!
Printer friendly view of this Ford topic
