This is topic vortech internals? in forum Tech Talk at Northern California Ford Owners  .


To visit this topic, use this URL:
https://californiafords.com/cgi-bin/ultimatebb.cgi?ubb=get_topic;f=6;t=005319

---

Posted by 91GR40LX (Member # 1329) on :
 
Anyone on the board take apart an S-trim? Had a question which way the race goes on the bearing goes inside the front case(it sits behind the tensioner screw). Ears towards the pulley or towards the impellar? vortech wouldn't tell because of liability bullshit! Thanks.
 

---

Posted by LAST302 (Member # 808) on :
 
Call Apex or Mustang Ranch, I am sure that they will be able to tell you. Are there any wear marks to indicate this, look for that. Good luck!!

You may also try calling some custom polishing shops. They usually take apart the blowers when doing the polishing so they may also know.

[ September 04, 2003, 03:15 PM: Message edited by: LAST302 ]
 

---

Posted by st5150 (Member # 51) on :
 
You should post this in the supercharger section of www.corral.net/forums
 

---

Fueled by Ford Mustang Owners
on CaliforniaFords.com