T O P I C R E V I E W
|
LAST302
Member # 808
|
posted
I got my 95 stang sold and it is being shipped tonight or tomorrow. Its got a 306 with a vortech. I have been sucking oil through the pvc into the upper plenum and burning it back through. I know its common but what are you guys doing to eliminate this problem? Thanks alot
|
91sleeper
Member # 779
|
posted
Isn't that called blow by You can always cap the pcv and then put it back on for smog time.
|
LAST302
Member # 808
|
posted
Are you sure that you can just cap the pvc on the lower mantifold without having to create a new vaccuum source somewhere else or having to relieve crankcase pressure somewhere else? Remember its a boosted car!! What ya think?
|
Black94 5.0
Member # 655
|
posted
Run a breather on the valve cover and make sure you cap off the tube comming off the valve cover to the intake tube....Then install a breather where the PCV valve is and cap off the intake...I have a small K&N breather in place of the PCV valve and it works great!...
Basically, with 2 breathers it allows the blow-by to escape easy and lowers crank-case pressure... [ August 04, 2003, 11:29 AM: Message edited by: Black94 5.0 ]
|
hopdup95
Member # 2381
|
posted
I've got a similar problem with sucking oil back into the intake. I put a breather on the driver side valve cover and put a gromet into the passenger side valve cover to cap it off. Is there anything more I should do. I still have a crap load of crank case pressure because its pinging and my dip stick is being pushed out.
|