T O P I C R E V I E W
|
88DroptopGT
Member # 2535
|
posted
Sorry if I'm asking a n00b question, but my '88 roller Notch needs a tranny. On the tranny, what parts do I need to complete the assembly? So far I have this list:
T-5 Tranny Mounts Double Hump Cross. (It's a V8 though.) 28 oz Flywheel for 302s T-5 Bellhousing Clutch Fork Clutch Cable Clutch Plate Drive Shaft to 8.8
It was previously a manual, so I have the pedals. I feel like I'm missing something however, thanks for the advice in advance.
|
FasterDamnit
Member # 442
|
posted
50 oz. for an '88.
Check out www.fordmuscle.com , the tech section under transmsission.
|
st5150
Member # 51
|
posted
There are a bunch of little stuff like the clip that holds the clutch cable to the bell housing, the "dust cover" for the clutch fork, ect
|
Saint
Member # 2746
|
posted
throw out bearing and piolet bearing. i would get a new rear main seal too
|
MoostangGT
Member # 2894
|
posted
Do you still have the clutch quadrant, might be a good time to go to an aftermarket since you are putting in a cable anways.
|
Sean90GT
Member # 33
|
posted
I just got my website back up so you can click on the link in my sig and follow the link at the bottom of the page for the T5 swap parts list. That should about cover it.
Sean.
|
88DroptopGT
Member # 2535
|
posted
quote: Originally posted by Sean90GT: I just got my website back up so you can click on the link in my sig and follow the link at the bottom of the page for the T5 swap parts list. That should about cover it.
Sean.
Very Helpful. Thanks for the complete list.
|