T O P I C R E V I E W
|
Black88GT
Member # 394
|
posted
The car runs fine, but when I get on it at all, it misses. Its like if I gradually get on it, Its ok, But If I press the accelerator hard, It misses. I just did new wires, cap and rotor,and Also plugs. What could It be?
|
93PONY
Member # 60
|
posted
Did it miss with the old wires?
|
Black88GT
Member # 394
|
posted
No, but we changed alot of things at once. [ December 22, 2002, 05:40 PM: Message edited by: Black88GT ]
|
93PONY
Member # 60
|
posted
Sometimes you get a bad batch of NEW wires. It's happened to me with FMS 9mm wires. Swap the old ones back on & see what happens.
|
PonyBoy
Member # 1744
|
posted
check your timing!
|
Tri-Bar
Member # 2191
|
posted
Check you TPS and ajust if needed. shoud be around .98 an the meter. That were I like mine.
|
91sleeper
Member # 779
|
posted
You crossed up your plug wires I know it, you did it when you installed your new ones. Double check them.
|
99gt-UJSTLST
Member # 584
|
posted
sounds like a vacume leak check all your connetions to make sure you got them all connected and nothing broke off thet vacume tree
also I would double check the wires make sure they are in the right order
|
CobramanPhil
Member # 2170
|
posted
Check the routing...especially the #4 and #5 cylinder wires. Separate those guys and make sure they are not too close...do that for all the wires and let us know. I'm wondering if your getting interference between the wires...
|
1sic91blackgt
Member # 868
|
posted
check the wires man i did the same thing i messed up the 3 and 4
|
91sleeper
Member # 779
|
posted
It's a common mistake...
|
Black88GT
Member # 394
|
posted
OK I swapped all the wires, and it ran ok for a minute, But then it was back to the same thing, it still hesitates. Check this out, if I floor it, its fine. What could it be. The timing is at 10.
|
sic91blackgt
Member # 868
|
posted
did u check all ur plugs??? maybe one is fauled....
|
Black88GT
Member # 394
|
posted
quote: Originally posted by sic91blackgt: did u check all ur plugs??? maybe one is fauled....
I just did that today and it runs 100 times better now, but It still misses. I dont know what to try next, any ideas? Thanks for the help guys.
|
sic91blackgt
Member # 868
|
posted
well you can check your cylinder compression but you will have to go to a shop to have them test it... what else did u replace ?
|
Quick 88LX
Member # 1950
|
posted
What about your ignition or fuel delivery?
|
Black88GT
Member # 394
|
posted
The ignition is stock. As for the fuel, It has a new 255 in tank.
|
Black88GT
Member # 394
|
posted
The ignition is stock. As for the fuel, It has a new 255 in tank.
|