T O P I C R E V I E W
|
mastercudaz
Member # 7486
|
posted
Anyone know if or how its possible to remove the screen below the PCV vavle without removing the lower intake? 5.0 engine
|
93ReefBlue5.0
Member # 5780
|
posted
yah, its easy. just have small enough hands to get in between the firewall and manifold... it comes right out...
|
hidnn.o.s.
Member # 1219
|
posted
Magnet?
|
89Rodknocker
Member # 2951
|
posted
I hope your only taking it out to clean it because if not you'll suck oil.
|
mastercudaz
Member # 7486
|
posted
hmm it seems to be down inside there a little far to reach with my hands, its inside the hole under the grommet.
I am trying to take it out to replace it. The car didnt have a grommet or the pcv valve to I want to replace it and make sure its all new. who knows how long its been missing.
|
mastercudaz
Member # 7486
|
posted
I read in a couple places that you can use a big screw and screw it into the middle of the "birds nest" and then pull it out.
Can anything fall down into the engine under this screen?
|
89Rodknocker
Member # 2951
|
posted
Theres a plate riveted onto the bottom side of the lower intake to help keep oil splash from reaching the pcv and helps prevent debris from falling inside of the valley. If you have a new grommet and screen. Get a set of long needls nose pliers or long screwdriver and pry the grommet out. You then can use a magnet or long hook and pry it out.
|
turbo50
Member # 6700
|
posted
I use small 90 degree needle nose pliers. Work like a charm!
|