T O P I C R E V I E W
|
1993GT
Member # 7948
|
posted
got a motor runing in a 1990 gt and sounded like a cylinder waas missing, so i did a quick compression test and that cylinder pulled 60lb of pressure.Pulled valve covers off and turned it over everything working according to order nothing loose or broken. So i took the head off the passanger side. i am going to put another stock E-7 head and was wondering if i should replace the lifters or pushrods?? [ February 05, 2009, 01:16 AM: Message edited by: 1993GT ]
|
jaejae
Member # 7958
|
posted
replace lifters pushrods should be fine
|
92stangLX
Member # 3252
|
posted
What did the compression in the other cylinders read?
I would have thought that low compression would have indicated a problem with the rings
|
Pai
Member # 8901
|
posted
Why are you replacing the head? How do you not know its not rings?
|
85_TT_5.0
Member # 8486
|
posted
Low compression in a cylinder could be caused by a bad valve or bad rings, squirt a little oil in the low cylinder if the compression increases you probably have a bad ring. if you don't see any increase in the compression then you have a bad valve.
|
1993GT
Member # 7948
|
posted
its a little to late to squirt oil head already off, will do next time, but all other cylinders read 160-180 or so, thats why i wanted to assure it can be a lifter so i can go ahead n replace them aswell..could the lifter cause it too? [ February 04, 2009, 07:05 PM: Message edited by: 1993GT ]
|
92stangLX
Member # 3252
|
posted
Well, at this point you may want to have a machinist inspect that valve now that you have the head off.
If it looks ok the only thing to do is put all the shit back together and then do another compression check to see where you are at.
|