T O P I C R E V I E W
|
menlo pony
Member # 4301
|
posted
I just bought a universal oxygen sensor from kragen for my 4 door, 1998 honda civic dx . I wanted to make sure that I connected the wires properly. If I am correct the:
signal wire is WHITE.
(2)heater wires are BLACK.
and ground wire is GRAY.
Please let me know if this is correct. I google'd it really quick, but I couldn't find it. [ June 14, 2005, 04:51 PM: Message edited by: menlo pony ]
|
menlo pony
Member # 4301
|
posted
And how long should it take the check engine light to turn off, after I replaced it?
And yes I'm sure that was what caused the check engine light to go on. I took it to the dealer, but they were going to rape me on parts and installation, so I did it my self.
|
Jay Taylor
Member # 5757
|
posted
your going to need to reset the ECU before the MIL(check engine) light goes off. just inplug the batter for a few minutes and then drive it aroud
|
menlo pony
Member # 4301
|
posted
quote: Originally posted by Jay Taylor: your going to need to reset the ECU before the MIL(check engine) light goes off. just inplug the batter for a few minutes and then drive it aroud
Thanks, it worked. Would the light turn off even if I did not fix the problem. Or would it turn on later, if I did not fix the problem (and only unplugged the battery)?
|
blind
Member # 3052
|
posted
it'll be back in about 300 miles if the problem wasn't fixed
|