T O P I C R E V I E W
|
El komander
Member # 10751
|
posted
I'm trying to install my temp gauge but don't know what I need , was told it was electrical , what would I need wires? , lines, sending units? Thanks for looking ca fords
|
RAP66
Member # 3360
|
posted
a little keyboard action
http://www.autometer.com/cat_gaugedetail.aspx?gid=3113&sid=11
directions: http://www.autometer.com/productPDF/2650-1079-00rC.pdf
going from that info... Middle post = Ground Labeled "S" = to sending unit Labeled "I" = switched 12v source
the one at the top is your lamp so one side will need a ground, the other you need to tie into your dash lights, or switch 12v source.
|
El komander
Member # 10751
|
posted
quote: Originally posted by RAP66: a little keyboard action
http://www.autometer.com/cat_gaugedetail.aspx?gid=3113&sid=11
directions: http://www.autometer.com/productPDF/2650-1079-00rC.pdf
going from that info... Middle post = Ground Labeled "S" = to sending unit Labeled "I" = switched 12v source
the one at the top is your lamp so one side will need a ground, the other you need to tie into your dash lights, or switch 12v source.
Thanks a lot this really helped me out But we're are the sending units?? [ 2013-09-28, 04:44 PM: Message edited by: El komander ]
|
Tom Renzo
Member # 13165
|
posted
YES you need a sender installed in the block in one of the water jackets so it can read the TEMP. Did you not get one with the GAUGE, You should have!!
|
El komander
Member # 10751
|
posted
quote: Originally posted by Tom Renzo: YES you need a sender installed in the block in one of the water jackets so it can read the TEMP. Did you not get one with the GAUGE, You should have!!
I didn't, I just got the gauges themselves , would you happen to know the part number for it?
|
Tom Renzo
Member # 13165
|
posted
Call or e mail Them and they will send you the correct one. Good luck!!
|