|
Author
|
Topic: Anyone put 6x9s in place of stocks?(sn95-new edge)
|
Murder mach
¯
Member # 10590
|
posted
 
 
I have a o1,can I put 6x9s in the rear,and doors?
Posts: 860 | From: stockton area | Registered: Jan 2011
| :
|
|
CornOil_&_Boost
¯
Member # 5888
|
posted
Not sure about the doors but I had to mount my 6x9s from The bottom on my rear Deck...
I went 5x7s up front along with kick panels in the footwells
[ August 29, 2011, 10:50 PM: Message edited by: CornOil_&_Boost ]
--------------------
https://www.facebook.com/pushrodpoweredmustangs
'95 Cobra - small engine / small turbo -
'02 Excursion 7.3 - tow vehicle
'14 - Chevy Volt - DD
Posts: 5097 | Registered: Jul 2005
| :
|
|
Murder mach
¯
Member # 10590
|
posted
So you lay in the trunk and drill new holes? I seen stock the mount from under,looks like the would fit tho right? Without cutting anything?
So you left the door speakers?
Posts: 860 | From: stockton area | Registered: Jan 2011
| :
|
|
Murder mach
¯
Member # 10590
|
posted
Also wondering can I use my stock amps,a new deck and add a bass amp? I did buy the deck harness
Posts: 860 | From: stockton area | Registered: Jan 2011
| :
|
|
CornOil_&_Boost
¯
Member # 5888
|
posted
quote:
Originally posted by outlawdragger:
So you lay in the trunk and drill new holes? I seen stock the mount from under,looks like the would fit tho right? Without cutting anything?
So you left the door speakers?
Yes, didn't have to cut anything just mounted from the bottom instead of the top.....
The fronts I replaced but stock size speakers but with a huge magnet...
[ August 30, 2011, 03:03 AM: Message edited by: CornOil_&_Boost ]
--------------------
https://www.facebook.com/pushrodpoweredmustangs
'95 Cobra - small engine / small turbo -
'02 Excursion 7.3 - tow vehicle
'14 - Chevy Volt - DD
Posts: 5097 | Registered: Jul 2005
| :
|
|
RAP66
¯
Member # 3360
|
posted
I did component 6 1/4 in the front and 5x7 in the back as filler & an 8" sub.
Depending on your stereo needs, component speakers are the better way yo go.
--------------------
91GT Kurgan Tuned:12lbs of boost 492.4 rwhp / 483.1 rwtq
http://killcarb.org/
www.fordstrokers.com
Posts: 893 | From: SF Bay Area | Registered: Oct 2003
| :
|
|
CornOil_&_Boost
¯
Member # 5888
|
posted
here's my setup
Qlogic kick Panels with Fosgate T1652-S in them
in the door: Fosgate T1572 Speakers
in the rear deck: Fosgate T1693 Speakers
[ August 30, 2011, 05:42 PM: Message edited by: CornOil_&_Boost ]
--------------------
https://www.facebook.com/pushrodpoweredmustangs
'95 Cobra - small engine / small turbo -
'02 Excursion 7.3 - tow vehicle
'14 - Chevy Volt - DD
Posts: 5097 | Registered: Jul 2005
| :
|
|
Murder mach
¯
Member # 10590
|
posted
Thanks fellas,kinda dumb here,whats the differencd in a "componet" speaker? Didnt know they had speaker kick panels for these
Posts: 860 | From: stockton area | Registered: Jan 2011
| :
|
|
Murder mach
¯
Member # 10590
|
posted
i already had some pioneer 6x9's that are 3 way, wanted to use them, was going to get a deck and a sub and sub amp,wanted to use the stock amps for the speakers and us a harness to adapt a new deck, this 6 cd changer thing is lame.
Posts: 860 | From: stockton area | Registered: Jan 2011
| :
|
|
CornOil_&_Boost
¯
Member # 5888
|
posted
quote:
Originally posted by outlawdragger:
Thanks fellas,kinda dumb here,whats the differencd in a "componet" speaker? Didnt know they had speaker kick panels for these
here is kick panel with components out of my car
[ August 30, 2011, 06:42 PM: Message edited by: CornOil_&_Boost ]
--------------------
https://www.facebook.com/pushrodpoweredmustangs
'95 Cobra - small engine / small turbo -
'02 Excursion 7.3 - tow vehicle
'14 - Chevy Volt - DD
Posts: 5097 | Registered: Jul 2005
| :
|
|
RAP66
¯
Member # 3360
|
posted
I used to do the standard speaker system, 2way/3-way etc... If you're an audiofile I really suggest keeping the 3/2ways for filler sound. And do components (typical: mid/tweet & crossover) where you will be doing most of your listening <in the front of the cab> Your music will just "POP"; your highs will be highs, lows will be lows. It all depends on what you're into.
Try to match your setup, using RMS ratings for the power rating of the amp & speakers. Dont get a big ole amp and over drive the speakers then all you make is distorted noise.
Do your system right and it will sound awesome all the time.
My setup is all alpine: CDA-9884, MRV-450 5ch amp, MB Quart RCE-216, Lightning audo 5x7 3way(wally world speakers), 6 disc changer, Sirius Radio, and an 8in bazooka.
The bazooka was not the best choice but it worked for what I have. I would like a better sub, to tighten up the bass but could never find one that sounded good. Soundstream used to be one of the best out there but now BLEH... MTX, Fosgate, JL etc, sure they hit but to me it was like a 5dollar hooker.
6x9 in the back will mean some sort of cut, drill n fit. If your patient, creative and take your time you can almsot fit what ever you want.
Corn - where did you find those panels?? I could never find them. fox version??
[ August 30, 2011, 07:39 PM: Message edited by: RAP66 ]
--------------------
91GT Kurgan Tuned:12lbs of boost 492.4 rwhp / 483.1 rwtq
http://killcarb.org/
www.fordstrokers.com
Posts: 893 | From: SF Bay Area | Registered: Oct 2003
| :
|
|
87MclarenMustang
¯
Member # 10695
|
posted
If your looking for the component kick panels go to qlogic.com and click on the kick panels. From there you just follow instructions. They are 144.95 right now. Work best in an automatic due to not having to work the clutch pedal. They house either a 5 1/4 speaker and 2" tweeter or 6.5" speaker and 2" tweeter but if you use the 6.5 your gonna have to use the grilles that come with them. They sound amazing in these panels.
--------------------
Formerly 07SilverS197
Posts: 1282 | From: Brentwood | Registered: Feb 2011
| :
|
|
87MclarenMustang
¯
Member # 10695
|
posted
quote:
Originally posted by outlawdragger:
Thanks fellas,kinda dumb here,whats the differencd in a "componet" speaker? Didnt know they had speaker kick panels for these
A component system basically breaks down a 2 way speaker into its seperates. It usually consists of a 5.25-6.5 driver(sub), a 1-2" usually silk dome tweeter, and an external crossover. By seperating the 2 they are able to reproduce the sound at a much higher frequency and much smoother sound. They also usually handle much more power...
--------------------
Formerly 07SilverS197
Posts: 1282 | From: Brentwood | Registered: Feb 2011
| :
|
|
Murder mach
¯
Member # 10590
|
posted
oh i see, the kick panels arnt for me tho,i have a 5 speed and its even a little cramped for me now. ill just get good door speakers
Posts: 860 | From: stockton area | Registered: Jan 2011
| :
|
|
Email this post to someone!
Printer friendly view of this Ford topic
