rollininmy50
¯
Member # 9067
|
posted
yes it can b done , i have done it a few times, there is 2 lower bolts, either side of dash, then the 6 across the top, when installing the updated dash, i would go to any hardware store and get 3-3.5 inch self tapping screws, so you can self tap threw the stock made holes in the plastic of the newer dash, threw the fire wall, also after you take out the old dash, there will be some tabs were the old screws went in, youll have to cut them out, or bend them down, cause the new one will not b flush up to the windshield, it there left in place. carefull not to break the windshield, Good luck, and youll probably need to replace the harness too, and possibly the heater box, good luck.
Posts: 439 | From: sactown | Registered: Apr 2009
| :
|