|
Author
|
Topic: 04 stang powe seat in 95 stang. power cord different
|
caballosalvaje331
¯
Member # 8137
|
posted
 
 
hello guys i just picked up some 04 mustang gt seats. i all ready install them but the drivers power seat is different connection than my 95 seat. how to i get them to work? any help would be great. thanks.
--------------------
stangless but still own a ford
Posts: 343 | From: sacramento ca | Registered: Jan 2008
| :
|
|
06Xrunner
¯
Member # 6992
|
posted
I did the same in my 96 a couple years back... I think it is a 4 pin connector on the seat, correct? 2 of them are positive and 2 are negative if I'm not mistaken I just made my own little jumper harness, I connected both positives to the one 96 positive and the same for the negatives. If you can't figure out which is positive check the Chilton's or Alldata under the siring diagrams. God luck!!!
--------------------
01 Black GT 526WHP sold
2012 5.0 GT 625WHP sold
1984 Buick G/N Built and boosting...
Posts: 2124 | From: Chico, Ca | Registered: Aug 2006
| :
|
|
venomous99
¯
Member # 1917
|
posted
here u go. this describes what wires should be connected. if u want to keep the connector on the 03 seat, just use some wire to jump to the corresonding wires but u get the idea.
ON THE SEAT -
1. Remove the factory connector from the '03/04 cobra seats.
2. Connect both GREEN wires together. I used a crimp connector.
3. Connect a crimp connector to the BLACK wire.
4. Connect a crimp wire to the BLUE wire.
IN THE CAR -
1. Remove the factory connector from the seat power harness.
2. Connect a crimp connector to the BLUE wire (+12 volts).
3. Locate teh BLACK wire (GROUND), but DON'T Crimp YET!
4. Remove the factory seatbelt attachment from the car floor.
5. Disassemble the seatbelt and cut the 2 wires that connect under the console.
6. Check with a digital meter for continuity. One wire will have continuity to GROUND. Connect this to the BLACK wire and crimp.
7. The other wire from the seatbelt will need a crimp connector.
FINAL INSTALL -
1. Connect the 2 Black GROUND wires from the car to the BLACK wire on the seat.
2. Connect the BLUE wire from the car to the GREEN wires on the seat.
3. Connect the seatbelt BLACK wire to the BLUE wire from the seat.
4. Finish bolting in the seat.
--------------------
MKII Q7
89LX
Posts: 4811 | From: dc | Registered: Oct 2002
| :
|
|
caballosalvaje331
¯
Member # 8137
|
posted
yeah i got the seats to work. firs i made my own harness. i did not to cut anything. but i end up cutting both connectors off. cause i thought it was not making good connection. dummy me should check the fuse. the was out. but never the less i work. i cut the tow green power connectors from the 04 seats and i crimp those two with the green/white connector from the 95 seat. and the black connectors from 04/95 crimp those two. i believe the other wire in the 04 connectors is for safety belt sensor.
--------------------
stangless but still own a ford
Posts: 343 | From: sacramento ca | Registered: Jan 2008
| :
|
|
Email this post to someone!
Printer friendly view of this Ford topic
