Author
|
Topic: sn95 vs foxbody balljoints
|
66 AC COBRA
Nitrous King
Member # 904
|
posted
here is the dilema
1989 coupe with a griggs k member and a arm setup, the car used to have 95gt spindles and a bear brake kit
the brakes were sold with the spindles
I want to put on a set of 5 lug mark 8 style rotors and spindles from a fox, i actually have these parts already and plan to use them
I have heard that the sn95 spindles use different balljoints
so if i had sn95 spindles and switch back to fox crap, do i need to swap in different ball joints
-------------------- FFR AC Cobra 72 Vega - WCHRA Extreme 10.5
Posts: 6280 | From: Winters | Registered: Feb 2002
| :
|
|
JohnB
Tech Moderator
Member # 969
|
posted
Yup. You'd need to swap them out.
Swap control arms over. It's ALOT easier...and then sell the SN's!
-------------------- 1965 Shelby Cobra 1993 Cobra 2012 F150 Raptor 2020 GT500
Posts: 6523 | From: Orlando FL/Redding CA | Registered: Mar 2002
| :
|
|
66 AC COBRA
Nitrous King
Member # 904
|
posted
quote: Originally posted by JohnB: Yup. You'd need to swap them out.
Swap control arms over. It's ALOT easier...and then sell the SN's!
if it was just stock for stock theni would do it, but these are the nice control arms
ball joints cant be that bad
-------------------- FFR AC Cobra 72 Vega - WCHRA Extreme 10.5
Posts: 6280 | From: Winters | Registered: Feb 2002
| :
|
|
Quick 88LX
¯
Member # 1950
|
posted
I just realized that I have fox ball joints and sn-95 spindles. No problems here Car tracks perfectly at any speed and caster/camber is controlled via MM plates. I have even taken my wheels off and set them to the side and they wear evenly; no feathering or other signs of mis-alignment. Keep the balljoints dude they are fine. Unless they were swapped and are something other than fox joints? [ June 14, 2005, 03:27 PM: Message edited by: Quick 88LX ]
-------------------- "Men are Made, Not Born" Car Picture : http://www.angelfire.com/theforce/quick88lx/ Original Member #495. Can I get my number back?
Posts: 1785 | From: Fairfield, CA/Okinawa, Japan | Registered: Oct 2002
| :
|
|
66 AC COBRA
Nitrous King
Member # 904
|
posted
quote: Originally posted by Quick 88LX: I just realized that I have fox ball joints and sn-95 spindles. No problems here Car tracks perfectly at any speed and caster/camber is controlled via MM plates. I have even taken my wheels off and set them to the side and they wear evenly; no feathering or other signs of mis-alignment. Keep the balljoints dude they are fine. Unless they were swapped and are something other than fox joints?
thats the problem, this is actually for donny's car, so i have no clue what is in them
jonh- could you tell the difference bwteen 2 balljoints if i brought an a arm to you??
-------------------- FFR AC Cobra 72 Vega - WCHRA Extreme 10.5
Posts: 6280 | From: Winters | Registered: Feb 2002
| :
|
|