T O P I C R E V I E W
|
lightning89mg
Member # 2673
|
posted
SOLD [ June 04, 2009, 12:11 PM: Message edited by: lightning89mg ]
|
tlcluver21
Member # 9062
|
posted
what else is needed to be done besides the few things you stated for it to be ready to drive?
|
lightning89mg
Member # 2673
|
posted
To Do:
Wleding - last 2 bars in roll cage, subframe connectors, wheel wells need a small trim and a small bead on each side to close off completely.
Remove Power Steering Arm and Install new manual converter
Mount fuel line (I have all the mounting brackets, was waiting for the subfram connectors to be installed so I could run the line besides the rails)
The rear end yet complete is still a non-posi 8inch. I have the 9 inch housing and complete center, need to get axles and big bearing brakes and install. Or weld the spider gears together in the 8" to make it posi and let ir run until it breaks.
Tune motor.
Install / wire tachometer
Let front springs settle and then cut to appropriate height.
I wanted to add lexan windows, but that is up to the new owner.
Bodywork and lights if wanted. I have all the lights but pulled them to do some body work.
All electrical is good besides what is stated above. Motor and tranny of course in car, shifter installed, driveshaft / drive line all complete, just need to tune the motor and finish above to be good.
Thanks! [ May 22, 2009, 12:22 PM: Message edited by: lightning89mg ]
|
lightning89mg
Member # 2673
|
posted
TTT
|
WickedStang
Member # 7692
|
posted
If it comes down to parting it out pm ASAP! Iam interersted in some things.
|
lightning89mg
Member # 2673
|
posted
WickedStang, check PMs... TTT
|
BlowN67
Member # 4229
|
posted
price on rolling chassis?
|
lightning89mg
Member # 2673
|
posted
Hi Blown67, i actually dont have a price in mind... Feel free to shoot me an offer but I am actually pretty open and need it out soon.
Thanks!
|
fasthatch
Member # 7277
|
posted
quote: Originally posted by BlowN67: price on rolling chassis?
on roller with fuel system
|
lightning89mg
Member # 2673
|
posted
check pm
|
lightning89mg
Member # 2673
|
posted
Pics of the entire car


 [ May 24, 2009, 04:29 PM: Message edited by: lightning89mg ]
|
lightning89mg
Member # 2673
|
posted
TTT
|
WickedStang
Member # 7692
|
posted
Is it a stock hood?
|
PeNiNsula302
Member # 1061
|
posted
ttt
|
lightning89mg
Member # 2673
|
posted
Yes, I have the stock hood... But I dont expect it will suffice if an aircleaner is going to be ran at all...
TTT
Need to sell, price negotiable
|
1SLOWLX
Member # 558
|
posted
god damn big enough stall on that bitch...
|
lightning89mg
Member # 2673
|
posted
Need to get this out.. Price is very negotiable! TTT
|
lightning89mg
Member # 2673
|
posted
Last time before I part her out... $3800 cash!
TTT
|
19mystic96
Member # 7553
|
posted
part out time????
|
19mystic96
Member # 7553
|
posted
if so, i call dibs on front runners!
|
SacStangDriver
Member # 8304
|
posted
sold to me
|