ryancway
¯
Member # 7237
|
posted
 
 
I have a 98 vert white with black top black interior. 80,000x miles on chassis*slightly less since the car has 4.30 gears in it now no they are not buzzy and I have not calibrated the speedo yet. 10k on motor HCI shortblock cCP 11:1 pistons .020 over, manley I beam rods,clevite bearings plasma moly rings,all ARP studs,brand new crank,blueprinted, internally balanced to less than 1gram, heads have a stage 3 port and polish and 4 angle grind then hand lapped,hooker longtubes and Xpipe no cats sooo you'll need to put the stock down tubes and h back on or have someone hook you up. findenza aluminum flywheel,Spec3 clutch,fms aluminum driveshaft, pro5.0 shifter,
eibach sportline springs,kyb gr2 shocks sruts, grannitelli UCA/LCA upr 4 bolt CC plates steeda stress bar, steeda subframe connectors,autopower bolt in rollbar,saleen s291 spoiler,17x9,17x10.5 cobra rs with recent tires sumi htrz 255/285, flowmaster 2chambers, leather seats are perfect currently running a set of corbeau cr1 seats drivers side bolster is worn. new lower steering shaft,walbro 255 pump complete new fuel delivery module for 98 only uninstalled ($375 item good to have) 30lb injectors and 24s in car, prom 77 MAF,
I'm sure there is more but i can remember,
the car will need: rear wheel bearings, a dyno tune,sun visors (craigslist item $30) and a you to get a hookup smog. small burn on rear seat but I planned on doing a delete so I didnt sweat it.
my email is ryancway@gmail.com 925-812-2929 if you want pics
clean title ect ect ect. 12k firm.nearly 10g in the motor alone. also available is a nx wet kit (the motor is guaranteed to take up to a 300 shot properly tuned)for an additional $300 bucks (with car only)
--------------------
built short block ported heads and assorted bolt ons. I LOVE 4:30 gears!
Posts: 29 | From: pleasant hill | Registered: Nov 2006
| :
|
|
Email this post to someone!
Printer friendly view of this Ford topic
![[burnout]](graemlins/burnout.gif)
