T O P I C R E V I E W
|
2fstfru
Member # 453
|
posted
I have a 351w fuel injected motor with SVO alluminum heads, Comp cam 292 cam is for blower/nitrous GT40 upper and lower intake with 1 inch spacer Fluid dampr harmonic balancer 24lb injectors, Fordged pistons 8:5:1 comp... Comes with headers.
This is a complete TURN KEY motor from oil pan to upper intake. $3k or best offer! About 600-1k miles on motor. This is in a foxbody mustang. No rush to sell so no low ballers. Motor is still in the car and you can hear it run.
Also have a New 5 speed tremec 3550 with bullit proof bell housing, 11inch clutch to go along with the motor take both for 4k. You will not be disappointed Good motor,Sounds great, clean CLEAR motor oil. I plan to remove the motor/trans sold or not with in the next 2 weeks. [ September 28, 2009, 02:15 PM: Message edited by: 2fstfru ]
|
2fstfru
Member # 453
|
posted
ttt will be removed in 2 weeks.
|
BLK92NOTCH
Member # 3033
|
posted
check your pms thanks
|
2fstfru
Member # 453
|
posted
ttt
|
2fstfru
Member # 453
|
posted
ttt
|
2fstfru
Member # 453
|
posted
ttt
|
2fstfru
Member # 453
|
posted
ttt
|
2fstfru
Member # 453
|
posted
ttt
|
2fstfru
Member # 453
|
posted
ttt ready for nitrous/blower.
|
2fstfru
Member # 453
|
posted
ttt
|
2fstfru
Member # 453
|
posted
ttt
|
fam_lace
Member # 8565
|
posted
r u willing to sell just the short block i dont need the heads i have the same motor but spun a bearing after 300 miles pm me if u intrested
|
|