Author
|
Topic: Kooks 3001 Headers & Complete Exhaust
|
SteveL
¯
Member # 1241
|
posted
A complete exhaust setup from headers to tailpipe.
Kooks 3001 headers: 1 3/4" primary / 3" collector. The #8 pipe was dimpled so it wouldn't touch a Canton road race oil pan (see pictures). Both collectors have O2 bungs installed. Kooks adapter plates to mate to Ford bolt pattern. Special flat head bolts to attach adapter plates to heads. 2 1/2" diameter H pipe Dynomax 17747 mufflers (2 1/2" inlet / outlet) Turn downs. Gaskets and header bolts not included.
$500 for the entire setup or just the headers so you might as well take the whole thing.
These are uncoated headers. I cleaned them up but there will be some rust spots.
These headers are for Foxbody but they might not fit all cars especially with stock K member. Check Kooks website for what heads the 3001's are compatible with. You are responsible to insure this setup will work in your car.
The 2 1/2" pipe and mufflers might be too quiet for you guys. I needed to meet 90dB sound limit at Laguna.
I recommend 3/8" 12 point headers bolts. Check the length of the bolts. 1" bolts might be too long depending on what gaskets are used. I'll throw in a set of 7/16" head, 1" long bolts but they might not work.
Assembling the headers is a bit of a jigsaw puzzle. I highly recommend doing a dry fit before sealing everything up.
[ 2013-04-05, 02:53 PM: Message edited by: SteveL ]
Posts: 578 | From: San Jose, CA | Registered: May 2002
| :
|
|
|