T O P I C R E V I E W
|
Secnd2nun64
Member # 1431
|
posted
I'm in the process if figuring out my fuel system and wanted to see where all of you are purchasing your parts from. I priced out summit racing and I'm around $400 for everything I need. Not sure if that's good or bad. I was looking at getting pfte stainless braided hose 8an feed with all the necessary connectors which is strait x4,45 x2 and 90 x4 degree swivel fittings. Then my return is 6an with the same amount of connectors. I plan to run 8an aluminum under the car and use the stock 3/8 line for the return. Each one of those connectors is around $15, any other options out there?
|
Greasy
Member # 5258
|
posted
I buy my fittings from Summit, it adds up fast though. When I'm putting a fuel system together I can easily spend $300-500 on misc fittings. [ 2014-03-10, 06:57 AM: Message edited by: Greasy ]
|
Secnd2nun64
Member # 1431
|
posted
Ya, it definitely adds up fast. I was triple checking my cart to figure out why the hell it was so much! lol of course half the stuff I want is out of stock for a month too.
|
Blow_U_In_Reverse
Member # 12298
|
posted
If ur in the bay area, try Vic Hubbards in Hayward, CA.. theyre usually cheaper or price match summit, n have almost everything in stock.. thats where I got my lines and fittings when I did my fuel setup.. but yeah, it adds up reaaaal fast!! [ 2014-03-10, 12:10 PM: Message edited by: Blow_U_In_Reverse ]
|
70stang351w
Member # 9948
|
posted
just got mine from summit, paid about 160 for mine and that was just from the carb to the fuel pump.
included the tools to assemble the line and 3ft ss line 7 fittings. filter and ss dual feed lines for 4150 carb
|
QuarterHorse / Slick
Member # 11882
|
posted
quote: Originally posted by Blow_U_In_Reverse: If ur in the bay area, try Vic Hubbards in Hayward, CA.. theyre usually cheaper or price match summit, n have almost everything in stock.. thats where I got my lines and fittings when I did my fuel setup.. but yeah, it adds up reaaaal fast!!
+1
|
wilit
Member # 3367
|
posted
Got all mine from Summit. AN stuff ain't cheap, so make sure you only buy what you need. Try and minimize angled hose ends and use angled fittings instead since hose ends are twice as much as fittings. Try and use as many straight connections as you can. You'll save some $$$ there. [ 2014-03-10, 07:55 PM: Message edited by: wilit ]
|
5.0 LsX
Member # 10017
|
posted
jegs has an off brand that is a lot cheaper. ive used quite a few for diff applications and cannot tell the difference
|
Secnd2nun64
Member # 1431
|
posted
Thanks, I'll check jeggs again but recall I didn't see a house brand for ptfe hose ends.
|
50Reasons
Member # 6452
|
posted
Try earls performance
|