This is topic UPR caster camber plate knocking on bumps in forum Tech Talk at Northern California Ford Owners .
To visit this topic, use this URL:
https://californiafords.com/cgi-bin/ultimatebb.cgi?ubb=get_topic;f=6;t=029852
Posted by naked5.0notch (Member # 14058) on
:
Hearing a knocking noise around the strut top area on the driver side hitting bumps. This is after the initial alignment
Set up is eibach sportline springs, kyb agx shocks/struts and upr caster camber plates along with upr upper and lower rear control arms
Posted by 510.86.notch (Member # 9892) on
:
Check your front sway bar mount.the spot welds on my wife's car started separated and making a clicking noise.just a thought.
Posted by naked5.0notch (Member # 14058) on
:
Will check that out. Just looks like the top mount knocks and moves around with all the bolts tight
Posted by NEIGHT (Member # 8741) on
:
quote:
Originally posted by naked5.0notch:
Will check that out. Just looks like the top mount knocks and moves around with all the bolts tight
The strut moves up and down with the bolts tight? Add a strut spacer
Posted by naked5.0notch (Member # 14058) on
:
The center rod with it tight moves up and down a little so the ball bearing is moving up/down on the driver side. Pass side is tight
Posted by naked5.0notch (Member # 14058) on
:
Can the caster/camber plates be rebuilt ?
Posted by *Als50* (Member # 6003) on
:
Send them back to UPR for replacements.
Posted by naked5.0notch (Member # 14058) on
:
Called upr they had some suggestions but I don't think they will take them back. They are roughly ten years old
Posted by *Als50* (Member # 6003) on
:
Mine are a little older than yours and i told them either repair or replace them since it was not problem that they were failing. Sent them back. Got new ones. Don't take NO for an answer.
Posted by naked5.0notch (Member # 14058) on
:
I will give that a try
Fueled by Ford Mustang Owners
on CaliforniaFords.com